Wired USB 2.0 Ethernet Adaptor 

Features

•     Integrated 10/100M transceiver

•     Auto-Negotiation with Next Page capability

•     Supports USB 2.0 and 1.1

•     Supports pair swap/polarity/skew correction

•     Crossover Detection & Auto-Correction

•     Supports Wake-On-LAN and ‘RealWoW!’ (Wake-On-WAN) Technology (see note 1)

•     Supports ECMA-393 ECMA ProxZzzy Standard for sleeping hosts (see note 1)

•     XTAL-Less Wake-On-LAN

•     Supports 25MHz or 48MHz external clock (from oscillator or system clock source)

•     Supports power down/link down power saving

•     Transmit/Receive on-chip buffer support

•     Embedded OTP memory

•     Built-in linear regulator (LDO)

•     Supports Customizable LEDs

•     Controllable LED Blinking Frequency and Duty Cycle

•     Supports hardware CRC (Cyclic Redundancy Check) function

•     LAN disable with GPIO pin

•     Supports LPM (Link Power Management)

•     SPI Flash Interface

•     Supports link change wake up

•     Supports Microsoft WPD (Wake Packet Detection)

•     Supports 16-set 128-byte Wake-Up Frame pattern exact matching

•     Supports CDC-ECM

•     48-pin QFN ‘Green’ package

Software Offload

•     Microsoft NDIS5, NDIS6 Checksum Offload (IPv4, IPv6, TCP, UDP) and Segmentation Task-offload (Large send v1 and Large send v2) support

•     Supports Protocol Offload (ARP & NS)

IEEE

•     Supports Full Duplex flow control (IEEE 802.3x)

•     Fully compliant with IEEE 802.3, IEEE 802.3u

•     Supports IEEE 802.1P Layer 2 Priority Encoding

•     Supports IEEE 802.1Q VLAN tagging

•     Supports IEEE 802.3az-2010 (EEE)