Instructions for fitting

1. Press at point(A) and mode slider(D) back a short way.

2. Insert the WiiMote as shown, inserting the base of the controller first.

3. Open the gun by releasing clip(B) and slide Housing(C) back, and out of the gun.

4. Feed the Nunchuck connector through the hole in Housing(C).

5. Slide the WiiMote back along the barrel so you can access the Nunchuck connector port on the base of the WiiMote.

6. Connect the Nunchuck connector to the WiiMote and slide the WiiMote to the end of the barrel with slider(D) and lock in place.

7. Slide the House(C) back into position.

8. Taking care to seat the cable in one of the cut-outs, close the gun at hinge(F) and lock in position with the Locking clip(B).

9. Now clip the Nunchuck into place at point(E).

To remove the Wiimote you wii need to unlock the slider at(A), slide back the slider(D), push the remote back into the barrel slightly and push underneath where the trigger is exposed. Remove the WiiMote, disconnect the Nunchuck cable unclip the Gun at(B) to remove the cable and Nunchuck.