Eapning Brake Hose Pipes Kit

PROFESSIONAL KIT FOR EARNING BRAKE LINE 10 ELEMENTS.

SET COMPOSITION:
Chrome plated, hardened and tempered swivel joint
Forged and heat treated steel clamping yoke
Easy-to-use conical press
Die sizes 4.75, 5, 1/4 ", 6, 8, 1/2", 10 mm
7 adapters for earning bits with sizes 4.75, 5, 1/4 ", 6, 8, 1/2", 10 mm
Brake hose cutter
The set is packed in a practical suitcase
A set for earning aluminum and copper brake lines and for making conical connection flanges.

PRINCIPLE OF OPERATION:
The end of the cable must be cut at right angles and cleaned of any sharp edges.
Place the cable in the hole in the holder and extend the cable to the desired length.
Clamp the cable tightly in the holder with the wing nuts.
Insert the adapter pin inside the hose.
Place the tip of the press over the adapter and tighten the press. until the adapter contacts the holder.
Remove the adapter - the end of the cable should be conical.
Screw on the tip of the press until the hose part opens.
Remove the cord from the holder.