Mobile phone tablet watch Charging dock stand DC 5V for apple watch iphone

Used for 5V apple watch and lightning iphone,itouch charging. 

Environment Working conditions
Voltage:DC 5V Input
Temperature: 0℃～+40℃
Humidity: ≤95%
Pressure:70kPa～106kPa
Cold storage Temperature :（-20±3）℃
Holding time:8h
Recover time:2h
appearance and function are OK.

Humidity storage :
Working temperature:（60±2）℃
Holding time:24h
Recover time:2h
appearance and function are OK.

Mechanism Plating
The outside iron parts should be tested with the Salt Spray,24 hours,and the iron parts should not be corrosion and the plating is still on.

Vibration
Fix the working dock on the vibrator,test conditions:
Amplitude 0.35mm
Frequency 10～50Hz
10 cycles on both sides.
After the test, the dock should not be loose,and work still on.

Drop test
Make samples drop from 60cm height to the hard wooden board(20mm thickness),six faces,,surface and electric property are not damage

Insertion/Withdrawal Force
Insertion Force 35N max,withdrawal Force 8N min,after 1500 cycles,Insertion Force 35N max,withdrawal Force 8N min.

MTBF
Output is 80% of full load,MTBF os less than 2000 hours

dock
Electrical data
standard status： out-put voltage：5V; (1m 24#) out-put current：1A+1A
No-load output：5V±0.25V;
Full-load output :Cable port（1m24#）：4.55-5.25V
Ripple current ：≤100mv
Short protection:Yes
LED:NO
Aging≧4 Hours
rotate：Place iphone in the lightning connector,iphone swings below 8 degree.the iphone doesn’t rotate.

Appearance
1.No burr,flash,scratch, flow mark, bright speck,shrinkage defects etc on the surface of product.
2. The width of art line on cover should be less than 0.5mm,intercept less than 0.3mm
3. Inner charger,it is not allow to shake